Product Specifications;
BATTERY CHARGING
1. Plug the charger in the wall power socket, the indicator light is green
In the free-load status.
2. Plug the port of the charger in the ports on the light. (the positive and
Negative polar doesn't matter, both ways work. )
3. The indicator light on the charger is red if the battery is not fully
Charged; It will turn green after fully charged.
4. Take out the charger and use the light.
ON/OFF
Push the switch to turn it ON.
MODES CHANGING
Successive push the switch ON-OFF within two seconds to cycle through High, Low, strobe, OFF.
SCUBA DIVING APPLICATION
Check closely for cuts, scratches, or an otherwise damaged O-ring or mating lens surface as this can cause the light to flood under pressure. Remove any salt deposits, sand, dirt, or other foreign matter from the O-ring sealing surfaces.
KEEP THE THREADS, O-RING GROOVE LUBRICATED WITH SILICONE GREASE.
| Model | Archon New Model WG96 Flashlight Rechargeable |
| Bulb | SST-90 LED *1 (max 2200 Lumens) |
| Color temperature | 6500 K (white light) |
| Reflector | 8° hot spot,110° periphery |
| Lens | 8mm Polycarbonate Board; |
| Battery | 18650 rechargeable Li- ion battery *6; |
| Battery Indicator | 100%-50%: Green; 50%-30%: Yellow; 30%-10%: Red; Below 10%: Red Flashing; Below 5%: switch off; |
| Protection | Polarity reversing protection. Gas release valve |
BATTERY CHARGING
1. Plug the charger in the wall power socket, the indicator light is green
In the free-load status.
2. Plug the port of the charger in the ports on the light. (the positive and
Negative polar doesn't matter, both ways work. )
3. The indicator light on the charger is red if the battery is not fully
Charged; It will turn green after fully charged.
4. Take out the charger and use the light.
ON/OFF
Push the switch to turn it ON.
MODES CHANGING
Successive push the switch ON-OFF within two seconds to cycle through High, Low, strobe, OFF.
SCUBA DIVING APPLICATION
Check closely for cuts, scratches, or an otherwise damaged O-ring or mating lens surface as this can cause the light to flood under pressure. Remove any salt deposits, sand, dirt, or other foreign matter from the O-ring sealing surfaces.
KEEP THE THREADS, O-RING GROOVE LUBRICATED WITH SILICONE GREASE.